Electrical problem at home? Talk to a licensed Newnan electrician.

Free estimates · GA License EN216120 · Mon–Fri 8–5

Do you need a whole-house surge protector? If you live in Newnan or nearby Coweta County, the short answer for most homes is yes — especially if you have a newer HVAC system, a well pump, an EV charger, smart-home gear or a home office full of electronics. The surges that wear those devices down don’t all come from lightning. Many start inside the house every time a big motor like an AC compressor, well pump or refrigerator cycles on.

Here’s how to tell whether a whole-house surge protector is worth it for your home, what it covers that a power strip can’t, and when to call a licensed electrician. If you’re ready for an install or a panel check, our whole-home surge protection in Newnan page covers how we handle it.

What Is a Power Surge?

A surge is a brief spike in voltage above what your home’s wiring and devices are designed to handle. It might last a tiny fraction of a second, but that’s enough to damage sensitive circuit boards. Surges come from a few places:

  • Lightning. A strike near power lines, a transformer or your home can send a large surge through the utility lines. Georgia summers bring plenty of thunderstorms, so this is the one most people know about.
  • Utility switching and outages. When power is restored after an outage, or when the utility switches equipment on the grid, voltage can spike as the lines come back up.
  • Equipment inside your home. HVAC systems, well pumps, pool pumps, refrigerators and other motor loads create smaller surges each time they start and stop. These are less dramatic, but they happen many times a day and slowly wear down electronics.

Whole-Home Surge Protection vs. Power Strips

A plug-in surge protector strip guards the few devices plugged into it, and only against surges coming through that outlet. It does nothing for hardwired equipment like your HVAC system, water heater controls, range, dishwasher, garage door opener, smoke detectors or the electronics built into newer washers and dryers.

A whole-home surge protective device (SPD) is installed at or next to your main electrical panel. When a surge comes in from the utility side, the device diverts the excess energy to ground before it spreads through your branch circuits. That covers every circuit in the house, including the hardwired appliances that are often the most expensive to repair or replace.

The best setup is usually layered: a whole-home device at the panel to handle the big surges, plus quality plug-in protectors at sensitive spots like TVs, computers and home office equipment to catch what’s left. Neither one replaces the other.

Is a Whole-House Surge Protector Worth It for Your Home?

Any home with modern electronics can benefit, but a whole-house surge protector is especially worth considering if you have:

  • A newer HVAC system or heat pump. Variable-speed systems and smart thermostats rely on circuit boards that are sensitive to surges. See our heat pump and HVAC circuit wiring page for related work.
  • A well pump or pool equipment. Common in rural parts of Coweta County, these motor loads both create surges and can be damaged by them.
  • An EV charger. Home chargers and the cars they connect to contain sophisticated electronics. Our EV charger installation service can include a look at surge protection at the same time.
  • A smart home setup. Smart switches, hubs, cameras, video doorbells and Wi-Fi equipment are all vulnerable. If you’ve added smart switches or USB outlets, protecting them makes sense.
  • A home office. If you work from home, a surge that knocks out your computer or router costs more than equipment.
  • A history of surge damage. If you’ve lost electronics after storms before, or devices seem to fail sooner than they should, surges may be part of the reason.

Surge Protection and Panel or Service Upgrades

Recent editions of the National Electrical Code call for surge protection on new or replaced residential electrical services. In practice, that means if you’re planning an electrical panel upgrade or a full electrical service upgrade, surge protection is usually part of the plan. Even if you aren’t replacing your panel, a licensed electrician can often add a whole-home device to an existing panel that’s in good shape.

One important note: a surge protector only works well when your home’s grounding and bonding are in good condition. Part of a proper installation is checking that the grounding system is sound. In older homes, that check sometimes turns up other issues worth fixing, like an outdated panel or loose connections.

What Surge Protection Can’t Do

It’s worth being realistic. No surge protector can guarantee protection from a direct lightning strike to your house. A whole-home device greatly reduces the risk from the far more common surges coming in on utility lines and from equipment inside the home, but it isn’t a lightning rod. Surge protective devices also wear out over time as they absorb surges. Many have an indicator light that shows whether they’re still protecting, and it’s a good idea to have yours checked after a major storm.

Signs You Should Have an Electrician Check Things Out

Surges can leave clues. Call a licensed electrician if you notice:

  • Electronics, chargers or appliance control boards failing sooner than expected
  • Devices that reset, reboot or lose their settings for no clear reason
  • Lights flickering or dimming when large appliances start
  • Scorch marks, a burning smell or warm spots at outlets or the panel
  • Breakers tripping or GFCIs acting up after a storm
  • An older panel with no surge protection, especially before adding big new loads

Installing a whole-home surge protector means working inside your electrical panel, where the main lugs stay energized even with the main breaker off. That’s not a DIY job. If anything on that list sounds familiar, our electrical troubleshooting and repair team can find the cause and recommend the right fix.

Surge Protection Across Our Service Area

Shocking Electric Solutions, Inc. has served Newnan-area homes since 2008 and holds a Georgia Class II Unrestricted Electrical Contractor license (EN216120). We install whole-home surge protection in Newnan and about 40 miles around, including Peachtree City, Tyrone, Sharpsburg, Senoia, Carrollton and Riverdale. Same-day and next-day appointments are often available, and estimates are free. Learn more about our Newnan electrician services and residential electrical services.

Protect Your Home Before the Next Storm

Call (678) 552-9399, or text (470) 516-7261. Many of our customers prefer texting, and our main line is a VOIP line that can’t receive texts, so please use the text number for messages. You can also email info@shockingelectricsolutions.com or visit us at 1002 Highway 16 W, Suite A, Newnan, GA 30263.

Electrical emergencies can happen anytime. If you smell burning or see sparks or smoke at an outlet or your panel, call us. See our whole-home surge protection in Newnan page to get started.